Hell's Bell

Materials

• 15-0200 Armour Etch Glass Etching Cream
• 21-1669 Over N Over Stencil-FLAMES
• Red Glass Bell

Additional Materials

• Soft Paper Towels
• #15-0315 Glass Cleaner
• #08-9606 Brushes
• #08-9999 Gloves
• #08-9415 Masking Tape

Directions

Preparation and Usage Starting Skills

• Over N Over Stencil Usage Instructions
• Armour Etch Usage Instructions

Project Steps

1. Please note- only true colored glass can be etched with cream. Always test before starting a project. Glass colored with tinted coatings or paints should be etched with sand. Additionally, removing the tape or stencil can cause the coating to chip or peel.
2. This design was etched in stages. The technique allows the use of a particular stencil image multiple times on the same project when you don't have enough to etch all simultaneously. Additionally, it enables stencil images to be placed in closer proximity than the stencil borders would otherwise permit.
3. After preparing the glass, place the flaming skull on the side of the bell with the flames centered bellow. Place a small flame at the top of the bell handle.
4. Temporarily remove or secure the clapper inside the bell. Follow the etching cream directions to etch these onto the bell.
5. Position the flame stencils on either side of the etched flames on the bell. Overlap the existing etching slightly.
6. Use the etching cream, as before, to etch the additional flames onto the bell. Replace or free the clapper inside the bell.