'Tis the SEAson- Crabmas Tree!

Materials

• #15-0200 Armour Etch Glass Etching Cream
• #21-1685 Over N Over stencil- SEA CREATURES
• #21-1611 Over N Over stencil- CHRISTMAS
• #21-1601 Over N Over stencil- SMALL BLOCK LETTERS
• #60-3570 COFFEE MUG

Additional Materials

• Soft Paper Towels
• #15-0315 Glass Cleaner
• #08-9606 Brushes
• #08-9999 Gloves
• #08-9415 Masking Tape

Directions

Preparation and Usage Starting Skills

• Over N Over Stencil Usage Instructions
• Armour Etch Usage Instructions

Project Steps

1. This design was etched in stages. The technique allows stencil images in the design to be in closer proximity than the stencil borders would otherwise permit. We also used a masking technique which allows for the selective use of certain parts of a stencil in specific locations
2. After preparing the glass, place the Christmas tree stencil on the glass as close to the bottom as possible. Cover all but the bottom two levels of the tree with masking tape.
3. Follow the etching cream instructions to etch this onto the glass.
4. Center the crab stencil over the tree bottom. Start the crab above the bottom limbs to get it closer to the base. Use the etching cream as before to etch the crab onto the glass.
5. Look through the back of the glass to place the top of the tree over the crab. Get as many tree rows as possible above the crab as the glass will permit. Use the etching cream to etch the tree top onto the glass.
6. Working from the top of the tree, place the letters in descending order along the sides of the crab tree. Etch these onto the glass with the etching cream to complete the design.